Pros: The install came out good. It looks much cleaner and less cluttered. II haven't actually gone out with it, but everything seems good.
Cons: The "instructions" were on a little tissue thin piece of paper and were basically useless. Though most anyone should be able to figure it out, most stuff only fits one way...
You'll definitely want a multi-meter. There were some discrepancies in wire color. The service manual said the common was green into the turn signals (which makes sense because the other wires were blue and orange for right and left). The green wires were actually the signal lines, while the other colored lines were common.
Did you find this review helpful?
Average Customer Rating:4.0 out of 5 (based on 2 ratings)
Pros: The install came out good. It looks much cleaner and less cluttered. II haven't actually gone out with it, but everything seems good.
Cons: The "instructions" were on a little tissue thin piece of paper and were basically useless. Though most anyone should be able to figure it out, most stuff only fits one way...
Comments: You'll definitely want a multi-meter. There were some discrepancies in wire color. The service manual said the common was green into the turn signals (which makes sense because the other wires... (Read the rest of this review)
Did you find this review helpful?
Clear Alternatives......NICE
By Ryan Morrison from PA, USA
Pros: The light is very bright, and rather easy to install!! Definately adds to the character of the bike!!
Cons: Didnt like the fact that the resistors were not integrated into the led board, there is not much room to stuf them back in the tail of the bike... And bye the way ignore the warning on the resistor packaging!!! They do not get that hot, they only started getting warm after about 6-7mins of my turn signal being on constantly!!
