Cons: do not buy this product. i hooked mine up with a wiring expert on hand. every connoection that should be soddered inside light was disconnected.
0 of 1 people found this review helpful.
Did you find this review helpful?
Average Customer Rating:4.0 out of 5 (based on 13 ratings)
Cons: do not buy this product. i hooked mine up with a wiring expert on hand. every connoection that should be soddered inside light was disconnected.
0 of 1 people found this review helpful.
Did you find this review helpful?
Great fit, poor wiring
By Steve from Nashua, NH
Pros: The tail light was easy to bolt into the bike, and looked stock once installed. It works as advertised.
Cons: Without the stock blinkers in place, it may be harder to pass inspection.
Comments: The wires were a nightmare. First, there was only one plug on the tail light and two other wires without plugs for the blinkers. The one plug that was attached was poorly manufactured, deformed and... (Read the rest of this review)
1 of 1 people found this review helpful.
Did you find this review helpful?
By DLee from Gainesville, FL
Pros: The lights look great once you get'em hooked up.
The overall outcome was great. The fit and finish looked great after install.
Cons: The wiring was the only issue that I experienced. Installation was pretty straight forward, but the wiring harness that came with the tail lights was not very impressive. The wiring harness had a loose ground wire. I had to cut the wire and splice it into the ground on the bike instead of doing a simple plug and play.
1 of 1 people found this review helpful.
Did you find this review helpful?
By JAMES from Wilmington, DE
Pros: IT REALLY A GREAT TAILLIGHT KIT FOR MY 07 CBR 1000RR,I ALSO TIE IT INTO MY COMPETITION WERKES FENDER ELIMINATOR KIT LTD.
Cons: NONE
0 of 1 people found this review helpful.
Did you find this review helpful?
Great looks however job is not complete
By Seif from UAE
Pros: its a great addition to the looks of the bike however the job is not complete without changing the Number plate mount. After installing Integrated tailight kit i had to remove the stock turn signals, the plate mount now looks a little bit weird so i advise that you buy a new plate mount to go with this upgrade. i bought PUIG fender eliminator kit and am just waiting for them to arrive!
Cons: NONE however i am bad with electricity so my dealer installed them. the electric wires where long and we had to use the resistors they get very hot so we place them under the seat behind the air intakes. Also one of the reviews mentioned that u can buy different resistors or flasher relay but i will wait to c how these one do before i change them.
5 of 5 people found this review helpful.
