Pros: Really dark, I'm a tall rider, so it's easier to tuck behind than the stock windscreen. Great quality and fitment. Love it!
Cons: None at all.
Comments: I recommend this windscreen for everyone with an 03-04 CBR. Thanks KneeDraggers!
0 of 3 people found this review helpful.
Did you find this review helpful?
Eh....
By M@ from Dirty Jersey on 09/12/2008
Pros: Look really nice with my graffiti cbr paint job, instructions were halfway decent.
Cons: VERY poor quality, don't really fit the bike advertised for, damn near impossible to see in daytime.
Comments: These things were a pain to put on. The orientation of the lights is REVERSE what the cut out on the fairing is, and you have to use like 5 spacers to KIND OF make them fit flush. I was VERY, VERY... (Read the rest of this review)
Did you find this review helpful?
By Anonymous from CA, USA on 07/21/2008
Pros: LOOK AWSOME VERY BRIGHT AT NIGHT EASY TO INSTALL
Cons: HARD FOR DRIVERS TO SEE IN DAY LIGHT
Did you find this review helpful?
By Eric from Rochester, ny on 04/28/2008
Pros: really easy to install and look awesome
Cons: May be hard for other people on the road to see because of how far in they sit.
1 of 1 people found this review helpful.
Did you find this review helpful?
Pretty crappy for the price
By Anonymous from Rockville, MD on 11/07/2007
Pros: Fit well and look pretty damn cool.
Cons: This things are pretty cheaply made. I was shocked by the low quality for the money. The first thing I had to do was pull off the crappy sealant where the wire goes into the back of the plastic and put some good sealant on there. They just used silicone and the sealant was half gone when I pulled them out of the box.
Also, my blinkers no longer blink. Mind you, I have completely removed my rear blinkers and can't say how it would work if I still had them, but the stock front blinkers still blinked after removing the rears. These just stay constantly lit. The instructions mention that they may "fast blink" and that adding resistors will solve the problem. But they make no mention WHATSOEVER of where these mystery resistors go, nor their wattage or ohmage.
Also, in installation, I had to supply my own metal washers. They give you plastic spacer/washers but they flex too easily and I'm POSITIVE the nut that holds the damn thing on would have loosened after a few rides.
Comments: I'm not sure what else is out there on the market. Like I said, they look good. If you're willing to look past the bad stuff and willing to pay a lot for a couple of cheap pieces of plastic then go... (Read the rest of this review)
13 of 13 people found this review helpful.
