|
Signal Dynamics Lighting Control Penta-Star Module
This module combines all of the functions of the Self-Canceling Turn Signal Module and the Tri-Star Module. Engineered for the custom builder or to retro-fit motorcycles not equipped with self-canceling turn signals. Designed for use with individual momentary type turn signal switches mounted on the left and right handle bars. Three Turn Signal Timing Modes - Self Canceling Hazard Mode - Non-Self Canceling Adds brake light function to turn signals Non-Load Dependent Flash Duration: all three modes are flash time constant whether using incandescent or LED lighting.
Features:
- Three Turn Signal Timing Modes - Self Canceling
- Hazard Mode - Non-Self Canceling
- Adds brake light function to turn signals
- Non-Load Dependent Flash Duration: all three modes are flash time constant whether using incandescent or LED lighting
- Dependable Solid-state electronic components.
- Weather Proof - potted with soft cell technology to prevent wire chaffing and damage.
Specification:
- Voltage: 12 VDC, Negative Ground.
- Max Load Capacity: 6 amps per left or right channel.
- Dimension: 2 1/4" L x 1 5/8" W x 5/8" H.
- Mounting: Secure to flat surface with double sided VHB tape (included).
Five Unique Turn Signal Modes of Operation
Mode 1 : Press turn signal button for 1 second, turn signal lights will flash for 7 seconds, then self cancel. This mode is usually used when changing lanes.
Mode 2 : Press turn signal button for 2 seconds, turn signal lights will flash for 20 seconds, then self-cancel. This mode is usually used when slowing down to go around a corner.
Mode 3 : Press turn signal button for 4 seconds, turn signal lights will flash for 75 seconds, then self-cancel. This mode is usually used when stopping at a signal light and turn will be made after stopping.
Note: All three modes above can be cancelled by pressing the same turn signal button a second time.
Mode 4 : Hazard Mode - is available all the time and will flash until cancelled. To engage, press both the left and right turn signal buttons for 1 second. To cancel, press both buttons again for one second.
Mode 5 : Brake Lights - Applying the brakes will cause the rear Turn Signals to light as long as the brakes are held. If a turn signal is sent to the rear lights at the same time it will have priority over the brake lights and cause the corresponding light to flash. When the turn signal is canceled the brake light will resume.
|
