Signal Dynamics Self-Canceling Turn Signal Module

Signal Dynamics Self-Canceling Turn Signal Module

• Engineered for the custom builder, or to retrofit motorcycles not equipped with self-canceling turn signals.
• Designed for use with individual momentary type turn signal switches mounted on the left and right handle bars. This unit will not work on bikes that have the left and right turn signal switch built into one unit that you must push to cancel.

Features:

• Three Turn Signal Timing Modes - self canceling.+ Hazard Mode - non-self canceling.
• Non-Load Dependent Flash Duration - flash time constant whether using incandescent or LED lighting.
• Dependable Solid-state electronic components.
• Weather Proof - potted with soft cell technology to prevent wire chaffing and damage.

Specification:

• Voltage: 12 VDC, Negative Ground.
• Max Load Capacity: 6 amps per left or right channel.
• Dimension: 2 1/4" L x 1 5/8" W x 5/8" H
• Mounting: Secure to flat surface with double sided VHB tape (included).

Four Unique Turn Signal Modes of Operation
Mode 1 : Press turn signal button for 1 second, turn signal lights will flash for 7 seconds, then self cancel. This mode is usually used when changing lanes.
Mode 2 : Press turn signal button for 2 seconds, turn signal lights will flash for 20 seconds, then self cancel. This mode is usually used when slowing down to go around a corner.
Mode 3 : Press turn signal button for 4 seconds, turn signal lights will flash for 75 seconds, then self cancel. This mode is usually used when stopping at a signal light and turn will be made after stopping.

Note: All three modes above can be cancelled by pressing the same turn signal button a second time.

Mode 4 : Hazard Mode - is available all the time and will flash until cancelled. To engage, depress both the left and right turn signal buttons for 1 second. To cancel, depress both buttons again for one second.