Average Customer Rating:5.0 out of 5 (based on 1 rating)
The complete rearset kit consists of the rearset plates, footpegs, 3 piece billet pedals and all of the needed hardware (shift rods, etc) to install the kit properly. This kit also includes a mounting point for the stock muffler. They are made from tough, aircraft grade 6061 T6 Aluminum. They are much stronger than OEM brackets and will give your bike a look that will separate you from the crowd. This kit is designed for the new R6 to give you the optimum foot position and ground clearance for racing and has already been tested and tried at Daytona. In the event that you need replacement parts, any individual piece of this kit is available.
Pros: Toughest aluminum I have ever seen. Crash after crash these things take a beating and don't bend. The pegs are replacible if they grind down too far. Three low sides and I haven't had to replace a part on them yet
2 of 2 people found this review helpful.
Pros: Toughest aluminum I have ever seen. Crash after crash these things take a beating and don't bend. The pegs are replacible if they grind down too far. Three low sides and I haven't had to replace a part on them yet
2 of 2 people found this review helpful.
Did you find this review helpful?
Related Woodcraft Hand/Foot Controls For Your Yamaha R6:
